EternaBond RoofSeal
RoofSeal/OneStep Go Back
For use on virtually all roofs, RoofSeal/OneStep features a UV stable backing that is available in Black, Gray and White. With the exception of surface prep, RoofSeal/ OneStep is a one-step permanent repair system for virtually all roof types, and roof accessories. RoofSeal/ OneStep creates a waterproof, moisture, and air tight barrier with no additional sealing required. RoofSeal/ OneStep remains flexible to temperatures as low as -57°C making it virtually impossible to thermally shock the seam causing a leak.
RoofSeal/OneStep bonds to a wide range of surfaces including difficult roof materials such as: EPDM, TPO, aged PVC, CSPE/Hypalon, CPE , SBS, APP modifieds, asphalt BURs, coal tar BURs, all metal roofs, tiles, shingle, aluminum, Galvanized steel, gypsum board, wood, polyethylene, propylene, polystyrene, fiberglass, brick, concrete, masonry, OSB, etc.
Basic Use
RoofSeal/OneStep tape is used to seal roof joints (seams) and tears, flashings, copings, skylights, gutters, etc. Perfect for repairing and restoring roofs on mobile homes and RVs. RoofSeal/OneStep seals to itself so it can be cut and folded around an object.
For info contact: info@eternabond.co.nz
Composition
RoofSeal/OneStep utilizes EternaBond’s advanced MicroSealant Technology, a 100% solids formulation of synthetic resins, thermoplastics and non-curing rubber (non butyl) with a built in primer. It is bonded to a UV stable backing. The adhesive coating is protected by a silicone release liner, to be removed prior to application.
Technical Data
| Adhesion | 9 kilos |
| Application Temperature | 66°C to -29°C ambient |
| Available Widths | Up to 121.9cm |
| Colors | Black, Gray, White |
| Elongation | >700% +/- 100 |
| Low Temperature Flexibility | 12.7mm radius at -34.4°C |
| Permanence | .001 perms maximum |
| Pliability | No cracks in membrane |
| Shelf Life | Up to 5 years |
| Standard Case Quantity | 30.5 sq. meters per case |
| Standard Roll Size | 5cm, 10cm, 15cm, 20cm, 30cm x 15.2m |
| Temperature Flexibility Range | 57°C - >93.3°C |
| Tensile Break PSI | 31 (kpa) |
| Total Thickness | 0.9 mils |
| Water Vapor Test | (ASTME 96B) .005 grms/24hrs/37°C |
|
NOTE: Values are typical performance properties and characteristics based on laboratory testing. This is intended as a guide for comparison purposes and does not constitute a specification or specification range. |
Surface Preparation
Surface must be clean and dry. Moisture, dust, dirt, or other foreign matter should be removed. Remove oil and grease, etc. with EternaClean or a non residue cleaner such as acetone or lacquer thinner. Remove salt and other contaminants.
Application
Install RoofSeal/OneStep over the repair area, removing the release liner gradually to prevent contamination of the adhesive prior to application. Rub or roll with pressure using your hand or a steel roller to activate bonding process. This material may be applied to clean dry surfaces from 66°C to -29°C ambient. Treat surface with EternaPrime for installations from 5°C to -29°C ambient.
For more info contact - info@eternabond.co.nz
Download our Limited Warranty (PDF - 21Kb)